This paper describes a low-loss submarine optical fiber cable for a long-distance submarine repeaterless transmission system that employs remote pumping. The features of this system are that it has an increased signal power budget and is cost effective and easy to maintain. First, we investigated the relationship between the signal and pump losses and the Raman gain efficiency of optical fiber needed to achieve a submarine repeaterless transmission system operating at 2.5 Gbps and over a distance exceeding 370 km. We manufactured a submarine optical fiber cable based on the results and confirmed that it had low-loss characteristics. Second, we evaluated the long-term loss stability of the optical fiber with a high-power continuous wave (CW) laser light as the pump source. We confirmed that the loss remained unchanged after 1900 hours of exposure to 8 W CW laser light at a wavelength of 1.48 µm. This submarine optical fiber cable is being employed in a commercial submarine repeaterless transmission system between Okinawa and Miyakojima.

A novel technique is proposed for measuring the distributed strain and temperature in a fiber with a very high resolution. This technique makes use of the jagged appearance of Rayleigh backscatter traces from a single-mode fiber measured by using a coherent OTDR with a precisely frequency-controlled light source. Our preliminary experiment indicated the possibility of measuring temperature with a resolution of better than 0.01 and a spatial resolution of one meter. This temperature resolution is two orders of magnitude better than that provided by Brillouin-based distributed sensors.

This paper proposes a novel fiber endface preparation tool for optical fiber joints that employs thermal surface cleaning and thermal endface cutting. This tool has great advantages in terms of fiber endface preparation time, and fiber endface stability when fiber is cut repeatedly. Stable thermal surface cleaning and thermal endface cutting are achieved by selecting suitable heating conditions. The fiber endface preparation time can be reduced to 50% of that required with conventional tools. The fiber endface stability obtained using thermal cutting is more than five times better than that obtained with the conventional tool using a blade.